Monday, April 4, 2016

Master Bedroom or What's stays behind walls...shouldn't!

 Do you know what's behind YOUR WALLS?

The second part of our whole house redo was the masterbedroom. Pretty good size for a small ranch the bedroom measures 11x14 feet. Here was the bedwall with the wall lamps inplace for next to the bed.

oldnewgreenredo

 The carpet and wall paper are old. We have had issues with cold spot in this wall. Part of the redo will be finding out why. Cold as in frosty and sweating? on a half/interior/exterior wall. About dead center is where the exterior window wall in the living room ends at the edge of the buffet. To the left the jog is where the furnace exhaust pipes go to the roof.


oldnewgreenredo

Opposite wall is our closets, which we did quite sometime ago, but never finished that little nook above the far left bathroom door. The doors were a splurge they were custom and solid wood, after some homemade ones didn't succeed.


oldnewgreenredo

 Hardest part was removing all the furniture and finding a place for it in the dead of winter. Most ended in the extra bedroom, on the screened porch and the living room. My trunk from when I was a kid, somewhere down the line ---will be a redo. Don't you think the decals are so 50's adorable.

oldnewgreenredo

 My bed wall---before---really was the country look of the late 80's. The carpet was pale peach and I was really glad to see it ripped up and gone. But on the sub-floor were water marks along the wall.


oldnewgreenredo

Ripping out drywall wasn't hard, just messy. Here is a problem....behind that patchy spot in the middle is a void area betweent he 2"x4" a 3"x3" hole floor to ceiling uninsulated. The insulation to the right is only rated an 8...so Hubby planned on replacing it all.


oldnewgreenredo

 I'm going to miss the wallpaper---I still love it.


oldnewgreenredo

The uninsulated area actually backs up to the buffet in the living room. That all seemed okay. But there were stains on the subfloor indicating water issues(sweating?) around the furnace corner.


oldnewgreenredo


 Hubby braved the small walls around the furnace. When the dust cleared, this is what we found.


oldnewgreenredo

The furnace flue was askew and not connected to the furnace...merrily pumping hot air into the uninsulated space that went directly to the 20 degree attic. This created our own little weather system. Very hot meets very cold equals condensation, not too mention carbon monoxide? Which apparently escaped through the well ventilated attic.

oldnewgreenredo

When did this happen? 2008 or so we had a near miss with a tornado and roof damage---which could have lifted all the connected pipes...? Or it wasn't properly installed when we got a new furnace a year or so before that.
oldnewgreenredo


This took three of us with straps to lift the insulated pipes, juggle a flash light and get the stack reset.  Hubby contacted our furnace maintenance guy (not the original furnace installer) to find instructions on what to do and what not to do.
oldnewgreenredo


With the exhaust pipe reset and properly taped, and the go-ahead to insulate the space with foam between the studs. Hubby began the overall insulation project. I wasn't any help here. He did the complete wall as we saw other water marks along that wall from condensation.


oldnewgreenredo

Canned expansion foam was used to fill  the exterior corner to the far right. Too many cans though---because most oozed out onto the floor.

oldnewgreenredo

Around the furnace corner thick foam insulation was carefull cut and fitted between the studs.


oldnewgreenredo

Hubby's plan was to make access doors on the one side...so if anyother problems occur with the flue...we can check on it.

oldnewgreenredo

 Next Hubby and a friend applied drywall, and screwed it in.


Add caption

The foam insulation took a bit of jiggering before measurements for the access doors could be made.
Next came taping and plastering.



oldnewgreenredo

Hubby is a super plaster man---with the proper corner tools he made short work of the three coats necessary to get a smooth surface. Forgot to mention the electrical was all updated and moved before the drywall went up. The outlets are now in the far corners and an original in the lower center of the wall.

oldnewgreenredo

With the furnace wall and the old bedwall being a new surface...we decided to remove the rest of the paper. It was expensive paper---highly washable, but with a flat finish. Turned out not easy to remove.

Removing Wallpaper

I tried scoring the surface, even beat it with the needle sharp paddles of my antique wool carders. Nothing really saturated the smooth but tight surface of this washable paper. Finally by saturating the edges of the paper, we peeled the top layer off when you could get an edge. The under paper (the dark tan you see), came off with multiple soakings and lots of scraping.

oldnewgreenredo

 Hubby did above and I did below...working in about two square foot areas at a time.

oldnewgreenredo

I was successful at getting the initial peel off and he was better at scraping. So we worked together, but this wall took about three hours.


oldnewgreenredo


Finally all the paper was scraped off  and then I had two scrubbings, and a vinegar rinse to finish it off.


oldnewgreenredo

 Here is the patched bare wall---with the peach original paint ala 1988 maybe?



oldnewgreenredo

 And the window wall.... another day and lots of team work.


oldnewgreenredo

 The wallpaper bagged up for the garbage men. Six bags of gooey wet mess.

oldnewgreenredo

While hubby painted the blue, I painted white trim...everywhere---everything needed new paint. The blue---is Flemish Blue from Pittsburgh Paints. We use satin as I really like being able to wash my walls. The blue and peach had me wondering if I would like it...cause together they were YUGH!


oldnewgreenredo

And, then there was all the unfinished moldings, trims, etc. Here Hubby frames out the trouble spot over the door.

oldnewgreenredo

 More painting, eventhough there was primer in the paint most areas took two coats.


oldnewgreenredo
 
More molding and trim. One day I painted all the pre-primed baseboards, and primed framing trim that were new. LOTS of trims and they all took at least two coats.

oldnewgreenredo

When the windows were finally all completely white I was ecstatic. LOVE the blue---it changes so depending on the light. This is a south facing window and is 86" wide, so there is plenty of light in this room.

This part of the redo---took about three weeks, because of all the waiting time between coats of plaster and paint. Curing paint between coats is a very good idea.  The fitting of all the pieces, cutting the trim, and painting multiple coats everywhere.

Next....the flooring, furniture, and hopefully the chandelier. I'm still playing with accessories and moving things around, but later this week!

Thanks always for stopping by. I'll be happy to answer any questions or comments.

All the opinions and photographs in this blog are my own unless noted.  I have not been paid or reimbursed in anyway for my opinions of products or posts. Please do not use photos without linking back to this blog without my permission. Thank you for your cooperation, Sandi Magle

Sandi

10 comments:

  1. I would think your heating bill will go down now that all the hot air isn't being pumped into the attic.

    Ick, removing wall paper is the worst.

    ReplyDelete
    Replies
    1. Well the chill off the walls hopefully will end, and a tropical rainforest in the attic...will be eliminated. Luckily we have lots of venting in the attic, so no molds. Thanks for commiserating, lol. Sandi

      Delete
  2. Big job and it looks wonderful as you progressed. So glad you found the source of the damp against the wall. What a lot of work to take everything off, appreciated your detailed photos. Looking forward to seeing the next phase of your bedroom reno.
    Joy

    ReplyDelete
    Replies
    1. I had been mumbling about those walls for quite awhile. Hopefully it will be healthier for the house, we are lucky there was no mold. Thanks forstopping by, Sandi

      Delete
  3. We just did the same in our bedroom a few months ago. Lots of work, especially removing multiple layers of decades old wallpaper. The result is worth the work, isn't it? I love the Flemish Blue, gorgeous color. Look forward to seeing more. :)

    ReplyDelete
    Replies
    1. Wallpaper is a pain, but I was sorry to see it go. But change is always good, just have lived with it so long. The blue is gorgeous in any light. Love it, thanks for stopping by, Sandi

      Delete
  4. Oh, my goodness!

    I hate that part of redoing the house when you spend so much time, money and effort on things that have to be done, but aren't seen.

    Thanks for sharing the reality of doing things right.

    ReplyDelete
    Replies
    1. Yes, well, yes 10 years or so after the fact. Grins, but once he puts his mind to it, everything is done right. We were just shocked though, when we opened the walls. Thanks for stopping by, Sandi

      Delete
  5. Oh what a job! Can't wait to see it finished. I had no idea that ship lap was behind the walls of some old homes until I watched fixer. Best of luck! Thanks for sharing with SYC.
    hugs,
    Jann

    ReplyDelete
    Replies
    1. Worse then ship-lap(which I have dealt with in an old Victorian)---was removing my parent' tiled counters: 34"plywood, nasty mesh and huge nails, 2" base of poured concrete...then the tile. I think the island penninsula weighed like 250 lbs because we couldnt' budge it until we got four people. We had no idea, when we started. Thanks for stopping by---my next posts are all pretty, LOL

      Delete

Thank you for any and all comments. I will be happy to answer any questions or comments in replies or email! HUGS!