oldnewgreenredo |
Last February my husband and I discussed the idea of building a Barbie Dollhouse for our granddaughter for this Christmas (2015). I had looked online and found all sorts of pink and purple abominations, vintage and new which had no relationship to a real house or real life.
However, there were tons of vintage/new furnishings in online stores and some great plans for DIY dollhouses. We decided, I should look for furnishings-cheap---because we could afford to build a quality dollhouse but not buy all new quality furnishings---and so my quest began, long before the dollhouse was even a sketch.
I began perusing thrift stores, Goodwills, Savers and online for inexpensive furnishings for a Barbie scale dollhouse (1inch to 6 inches). It was soon obvious that the 1:6 scale wasn't always easy to find. But, I did have some incredible luck, first starting with a few pieces.
oldnewgreenredo |
Here are the final plans, basically drafted around the furnishings we found and ended up using. The original plan was to have an island in the kitchen and no table as shown, but hubby found the great round wood table/set, so we readapted, but did not have to change the lay-out. We did make a drop leaf on the table, though to give Barbie and friends more room to move.
I can't stress enough how much planning we did, and how this saved time and sanity. I'm so glad we went with the stairs and 16" deep. The first thing the Grand did on Christmas was totter the dolls up and down the stairs...every time she moved them...so it was worth it. Not to mention the great views.
Here is the potential kitchen laid out to see if it would work and fit.
oldnewgreenredo |
The pink dishwasher is from a sink barcounter set in the "So Much to Do Kitchen" 1995. Because it was bar height I had to do some surgery on it. The wood table and chairs are from an antique mall, hubby found that---perfect size for Barbie. The new refrigerator was snagged from walmart for 10.97, a bargain in Barbie land. Here everything is laid out on the floor of the unbuilt house to make sure we will have enough room for stairs.
Basically the house was built around the furnishings we found.
oldnewgreenredo |
The old dishwasher was attached to a counter/sink combo, next pic. Working within the plans of the house as we were drafting it, it was going to be too high and the two-sided counter not going to work in the small area allotted for the kitchen. Pulling off the counter(again Mattel doesn' t make it easy to dismantle these things...I ended off coping sawing off the top 3/8" of plastic of the dishwasher.
oldnewgreenredo |
Here the old counter is still attached. The pink is absolutely gross. The dresser was not so bad, except we were going to use it in the livingroom, so an OLD REDO was necessarily for both. We did not end up using the locker---it didnt' fit under the stairs, but will be used at Grandma's house for play here.
oldnewgreenredo |
The NEW painted white dishwasher---I wrapped the basket in tape, and hubby added a shelf to the top, that might have been missing. We planned the kitchen cabinets, just like you would in a real kitchen. I never did find a vintage or inexpensive stove, so my hubby made that.
Extra cost added to the dishwasher---spray paint, painters tape and small shelf---minimal. counter top was used for all the cabinets, so maybe $1.50 extra for the dishwasher.
NEXT the VENDING MACHINE
oldnewgreenredo |
Another big score came with a practically new---Barbie Dream House Fashion Vending Machine-2013-4. Not really vintage, but purchased at Goodwill for $1.99.
source |
First thing I did was unscrew the back panel off...which consisted of two large filigree plastic panels, which I planned to use for the dollhouse windows, one in the bedroom and one in the bath.
oldnewgreenredo |
This REDO turned out so cool. I loved to take photos through them, so does the Grand.
oldnewgreenredo |
Isn't this neat...see the pony-tail head, center right? It's Barbie all the way.
Let me tell you----Mattel makes things really well, and I spent easily 2-3 hours trying to get this vending mechanism completely apart. The entire concept was cool, but just too many moving parts/mechanisms to make it work properly. It also had a spring load to push the chosen vending item into the slot to fall down the hole. Very complicated?
oldnewgreenredo |
After some sawing, unscrewing, unratcheting, clipping, hammering, and prying (cursing also involved)---I finally removed the vending belt mechanism.
oldnewgreenredo |
Lots of funky screws and pins held this together.
oldnewgreenredo |
Next I dremel tool-sawed the center stickered vending machine area out. WOW! It had little reinforcement ledges inside---I used to hold up shelves. Here are four small wooden shelves inserted and painted hot pink to match the plastic. Everything was Gorilla glued in place.
oldnewgreenredo |
The bottom center has a trimmed plastic bottle clothes bin. A plastic pin was trimmed and glued for a handle.
oldnewgreenredo |
An aluminum clothespole was added on the right for hanging clothes and screwed in place. The original left spinning turntable works for shoes and purses. I did not put a rear wall on it...as shoes can become trapped behind the turntable, another design flaw on Mattel's part...but say it makes a nifty REDO closet---Mr. Mattel. The Grand can pull the whole thing away from the wall and unjam it. She put the brush and toothpaste on the shelf there and moved the towels around.
Cost added, minimal--50 cents for the bottle clothes bin and maybe 50 cents for the shelves paint, etc.
So two windows, shoe/purse storage, towel storage, clothesbin and closet with doors, for $2.99 and a couple hours of cursing under my breath.
oldnewgreenredo |
The toilet and sink were purchased for $10.97 in a 2015 Barbie kit. I never did find any toilets or sinks in the 9 months of looking for vintage or used.
Savers had great bags of miscelanneous---it took two 1.99 bags to get the parts for one bathroom and a tub for this bathroom.
The tub to the left was part of a bag of goodies from savers. Originally it attached to
the "All Around Bathroom Play Set", by Mattel 2002, that I found in another bag. The only fix for the tub, was to build it in with a 'tiled' planter on the open end where it had originally attached to the funky blue shower walls for Ken's bathroom.
oldnewgreenredo |
The planter was a 2x4 cut off 3 1/2" high and 'tiled' modge-podged to match the
walls. Three holes were drilled and then filled with plants and the
whole thing was secured to the walls, and floor, permanently like real plumbing including the toilet nad sink.
oldnewgreenredo |
Here is the window panel from the back of the vending machine, the tub and planter---all installed. Don't you just LOVE IT~!?
oldnewgreenredo |
Here is the rest of the goofy shower walls for that set from "All Around Bathroom Playset" from 2002.
oldnewgreenredo |
All the parts were there, including yuggy decals, but the hinges went over 350 degrees...so it was very flexible to use however you wanted.
oldnewgreenredo |
First, I removed the stickers and all the loose pieces that popped out.
oldnewgreenredo |
This wierd litttle vanity in purple was supposed to be used from both sides? But, the top flips over to reveal the sink. I just finally took it completely apart to see how I could best use the pieces.
oldnewgreenredo |
Here's Ken with the proposed sink/vanity---but purple and pink, just weren't his colors...LOL. After wrapping all the 'metal' parts in tape, I cleaned everything twice with alcohol, and the built-in shower from the parts bags. I need to raise it a bit more---we did this with a small wood piece of candlestick part where the drain would be.
oldnewgreenredo |
I hand-sawed all the extra plastic pieces off the shower, and replaced them with the same molding we used on the ceilings. This helped to square up the shower and give some clearance to the parts in the back that were sticking out.
oldnewgreenredo |
Here is the newly painted blue shower parts, sans the add-on caps and stickers. Once cleaned with alcohol all the pieces were carefully sprayed with white gloss paint for plastic. The base is a margarine tub lid with thin piece of wood underneath to level it. Everything was glued with Gorilla glue which is permanent~including a bit of finger skin, here and there---that stuff really holds, lol.
oldnewgreenredo |
Hubby counter-sunk a screw to hold it together and then glued a washer on the hole for a drain.These pieces are glued in place in the dollhouse or screwed...just like a real house...permanent. The brown mirror is removable.
All the pink shower parts were sprayed with matte silver and I hand-painted the faucet. Oversize brown knobs were added to the vanity which also was squared up with a new wood top, the shower mirror was untaped after painting. A small plastic shelf was glued on before painting, from a goody bag of doll things from Savers.
Added costs to the bathroom-shower/sink... were paint, glue, washer, screws, wood trim, wood base, and knobs--less that $3.00. I'm still looking for the towel bar for the sink---it's in a bag---somewhere, in a box--somewhere. It will turn up or I will create a new one. All the shower parts turned out so cool. Eventually maybe a shower curtain will be added. I used gloss white paint...so everything looks so new and clean.
The Living room has some vintage in it also.
oldnewgreenredo |
The small chest of drawers on the right was the easiest REDO of all. It's from the Barbie, "So Much to Do Bedroom Collection" from 1995 and was perfect for the dining room area---where we needed some sort of buffet/endtable next to the couch.
oldnewgreenredo |
The dresser is shallow and has one working drawer...good lines and clean design. Perfect to go with the contemporary furnishings...sorta contemporaray cottage chic. LOL. It was simply cleaned and sprayed white.
oldnewgreenredo |
I didnt' even fuss with the knobs. Santa's deadline was coming down to the wire, so we decorated the top with some bottle trees, a lamp, and of course a cheese tray.
Added cost ---paint--25-50 cents for great storage in the living/dining room.
Remember this:
oldnewgreenredo |
I haven't been able to find the date on this, I thought it said 1998...yet I assume it isn't very old, and definitely Mattel Barbie...so this isn't probably vintage, but a great REDO. First---that color has to go.
oldnewgreenredo |
Here is the couch drying after one of three coats of green spray paint. Again very carefully cleaned with alcohol before painting...
oldnewgreenredo |
For the cover I chose 1" thick regular foam---$3.74 from JoAnnes. I used fabrics from several places, all cotton, so they will be able to be washed. I enclosed the cushion and permanently sewed and attached a skirt. The cover is strapped behind and velcro holds it tight on the green couch.
oldnewgreenredo |
The original Savers label, 1.99. You can see the strap and velcro on the back to the right.
oldnewgreenredo |
I also covered a bolster and made a few accent pillows. Definitely cozy enough to sleep on or for many guests or Ken's naps.
oldnewgreenredo |
Couch 1.99, fabrics 2.50, foam 1.00, stuffing and velcro, 50cents. Second couch was purchased new (IKEA) in a set with other items, and a new cover made for it another $2.00 or so.
oldnewgreenredo |
And its' all perfect for Ken to take another nap on Christmas Eve. The Grand put him there, not me, Lol. Now the Decor is not pristine, because it is a three-year-old's work in progress, but she was having a ball with two family friends.
oldnewgreenredo |
Barbie immediately took a bath, twice, and Ken napped while three little girls moved all the Barbie's and Ken's furnishings and clothes into the new house!
oldnewgreenredo |
It was a MERRY MERRY CHRISTMAS and have a Happy New Year,
from the Grand, Barbie, and Ken!
My Other DIY Barbie house posts in order:
DIY Barbie house Week 1 Planning
DIY Barbie House Week2 Cutting and Painting
DIY Barbie House Week 3 Windows
DIY Barbie House Week 3 Finally Color
DIY Barbie House Week 4 Assembly
DIY Barbie House Week 5 Stairs and Moldings
DIY Barbie House Week 5 Final Lighting
this post DIY Vintage Barbie Furniture
DIY Barbie House Moving in with Vintage Furnishings
DIY Barbie House Week 5 Final Lighting
this post DIY Vintage Barbie Furniture
DIY Barbie House Moving in with Vintage Furnishings
Thanks always for stopping by or leaving comments. I will try and answer all your questions and comments, they make mine and Barbie's day.
All the opinions and photographs in this blog are my own, I have not
been paid or reimbursed in anyway for my opinions or posts. Please do not
use photos without linking back to this blog without my permission.
Thank you for your cooperation, Sandi Magle
I will be posting to these great parties:
Metamorphis Monday
Inspire Me Tuesday
Something to talk about-link-party-49/
The Scoop
Show and Share
Let's Talk Vintage
Thrifty&Vintage Finds
Tuesdays at Our Home
Tweak it Tuesday
Share Your Cup Thursday
Share Your Style
Celebrate Your Story
Thrifty Vintage Finds
Talk of the Town
Flea Market Friday
I will be posting to these great parties:
Metamorphis Monday
Inspire Me Tuesday
Something to talk about-link-party-49/
The Scoop
Show and Share
Let's Talk Vintage
Thrifty&Vintage Finds
Tuesdays at Our Home
Tweak it Tuesday
Share Your Cup Thursday
Share Your Style
Celebrate Your Story
Thrifty Vintage Finds
Talk of the Town
Flea Market Friday
Sandi